Error in placing iFeature from Autodesk Vault 2014

Asked By James B Wiser 15 points N/A Posted on - 07/17/2013

Hello,

Recently, I have downloaded and installed a new version of Autodesk Vault but I got an annoying error message when I tried to add some file to the Vault like iFeature. I searched the solution to fix this problem but I could not find any assistance. I need your help immediately.

Thanks for any assistance.

Your files could not be added to the vault for the following reasons: The file C:userpublicdocumentsautodeskinventor 2014catalogpunches1-Nut plate Mount.ide is outside the defined search paths. You must either move the file into one of the defined search paths or add a new library search path to continue.

• Status: Open
• Question Views: 843
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Misc Software

Answered By Dorothy Brett 0 points N/A #158696

Error in placing iFeature from Autodesk Vault 2014

Hi James,

Please check the folders given if it is correct.

– Check one by one if the folders are still existing

– Check the location of the iFeature folder is correct

Use the instruction below for the series of testing;

1. Check and take note the location of the iFeature folder 

2. Open the "Application Options" 

– Under the iFeature root, iFeature user root, and Sheet metal punches root, it should be the same and correct location from the folder you have checked from instruction no. 1

About Dorothy Brett

Questions
0

Answers
10

Best Answers
3

• Vote Up 0 Vote Down

• Posted on - 11/13/2013
• Question Category: Misc Software