Route cannot be Satisfied because Hardware does not Support

Asked By chesley sielaff 20 points N/A Posted on - 05/24/2012

 

Can anyone help with an error code 200368 on my computer?

It says that the specified route cannot be satisfied because the hardware does not support it.

How can I change the terminal/route so it can be supported by my device? 

Thank you!

• Status: Open
• Question Views: 1186
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Misc Software

Answered By Pascarella Fernax 20 points N/A #156580

Route cannot be Satisfied because Hardware does not Support

Hi Chesley,

The error happens because the hardware is limited and signals cannot be routed to all terminals. You might be trying to input/output a signal on a terminal/route that is not supported by your device. Check the hardware documentation and/or max for valid signal routing on your device. And then, changing of terminal/route  might be needed or  adjusting the specification for signal reading.  To determine what signal routing allows refer to Measurement Automation Explorers.  Take this steps:

 1.  My system (highlight your hardware)

 2.  Device & Interface

 3. NIDAQmxdevice

 4. right panel Route tab

  green routes- means  direct routes that are wired on the device

  yellow routes- means indirect routes  and subsystem is used

  white routes- means  routes are not available on the device. Just be sure that the route you are using is not white. 

About Pascarella Fernax

Questions
5

Answers
131

Best Answers
8

• Vote Up 0 Vote Down

• Posted on - 06/01/2012
• Question Category: Misc Software