Getting error message on Network Connection

Asked By shaheed 0 points N/A Posted on - 09/23/2011

Hello,

I am a new user of Internet. When I tried to connect on internet via dial-up Internet connection the following message shows:

“An unexpected error occurred while configuring the Network Bridge”.

I do not have any idea why the message shows?

• Status: Open
• Question Views: 1451
• Answer Count: 2
• Vote Up 0 Vote Down

• Answer Accepted: Yes
• Question Category: Wireless Networking

Best Answer by Henry corn

Go To Solution

Best Answer

Best Answer

Answered By Henry corn 5 points N/A #128477

Getting error message on Network Connection

Hi,

This error message shows for many reasons. I don’t know what exact problem is but let us try. First for all check your connection. If you are using cable connection then check carefully. Is it working properly or not? Plug your cable connector perfectly with your pc. Then try to connect the internet.

May be you need an IP address to access the internet. If you don’t know that then collect it from your ISP company. Then use this IP address to connect. If you do not installed TCP/IP protocol then install it

 It is necessary if you are connecting through router. And also make sure that your connecting device is working properly.

About Henry corn

Questions
0

Answers
50

Best Answers
17

• Vote Up 0 Vote Down

• Posted on - 09/23/2011
• Question Category: Wireless Networking

Answered By Sharath Reddy 590495 points N/A #128479

Getting error message on Network Connection

Local area connection or a dialer has this configuration where you can set it into bridge mode. In a normal process, this icons should not be in this settings for unforeseen reasons, it'll probably been set by accident or mistake. This is the cause of the problem, if this function is miss configured.

When connecting to dial-up connection, the dialer has to be set and configure properly. when an error message is pop-up, AN unexpected error occurred while configuring the Network Bridge is caused by settings.

Right click on the network dialer, then un-bridge the network. This will let you connect to the Internet once the dialer connects to the server via dial-up connection.  Onc

 

About Sharath Reddy

Questions
1

Answers
14599

Best Answers
2290

• Vote Up 0 Vote Down

• Posted on - 10/09/2011
• Question Category: Wireless Networking