Remedy for Wet 3-in-1 Printer

Remedy for Wet 3-in-1 Printer

Hi Techdee

I will advice that you try using a blower to dry the affected parts of the printer. This blower should be one that kind of dries up the parts, but it should also remove the dust in from those parts. When water was spilled on printer, I hope you took the precaution of dis-assembling the parts and putting them apart to allow for drying before the water could navigate to other inner parts of the printer. (You can get a blower from a computer hardware and maintenance store that is near you, or a computer shop).

Hope this helps.

_____

Regards,

Lee Hung.

Remedy for Wet 3-in-1 Printer

If the printer is not working properly after accidentally spilling water over it, try drying it with an electric fan. Place the printer in front of an electric fan and remove the top cover. This way the wind coming from the electric fan will circulate around and inside the printer allowing any wet area to dry overtime.

If the printer still turns on, get the manual and try troubleshooting for common problems. If there’s a problem with the ink giving a bad print, try to remove and reinstall the ink cartridges. Check the manual how to remove the cartridges from the printer and installing it back. If the problem continues like the printer no longer turns on, in this case, you should bring it for repairs.

Bring your printer to the nearest repair branch for servicing.