IRC5 program error – start failed.

Asked By Teresa A Darby 0 points N/A Posted on - 06/21/2013

 

Hi.

I was just using my IRC5 to modify and recover some of my backup files.  I was asked to recalibrate/upgrade the revolution counters because the working station settings changed during setup so I had to go to a previous backup.
Everything was working fine till earlier on today when I saw that I was unable to run any program. My first thought was that I reverted back to a corrupted backup file but that was disproved when I ran a healthy backup from two years ago which prompted the same error.
I can't seem to find any sort of message that will give me a clue as to what is causing this (annoying!). I have included a picture and hopefully you can shed some light on this.
I'll be very grateful.

Start failed.

Unspecified error received from the robot controller.

See if there is more information in the event log.

OK

 

• Status: Open
• Question Views: 2813
• Answer Count: 2
• Vote Up 0 Vote Down

• Answer Accepted: Yes
• Question Category: Misc Software

Best Answer by Waters Magner

Go To Solution

Answered By Ailene Molfoy 0 points N/A #181862

IRC5 program error – start failed.

Hello!

Unfortunately reasons for this error can be numerous. First try to eliminate all errors from your code. Origins of this error are not known but as far as i know backup recovery and I-start should solve the problem.
If for some reason that won't do the trick, try updating your AAB Robotics program from 5.14.00 to 5.14.01 with SP1?

Hope that will solve your problem.

About Ailene Molfoy

Questions
0

Answers
10

Best Answers
2

• Vote Up 0 Vote Down

• Posted on - 11/17/2013
• Question Category: Misc Software

Best Answer

Best Answer

Answered By Waters Magner 5 points N/A #181863

IRC5 program error – start failed.

Hi,

There is problem with the robotics controller. It seems that the back up is failing due to the robotics issues. You need to check the robot outputs from the media server. You need to check the SAN zoning. It does look that there is some problem with the SAN zoning. The problem might be with San Zoning. You might try to add the virtual controller to the new station or go for Istart. This might be a solution to your problem as well.

About Waters Magner

Questions
0

Answers
199

Best Answers
32

• Vote Up 0 Vote Down

• Posted on - 11/18/2013
• Question Category: Misc Software