AutoCAD LT 2013 Launching Error

Asked By James D Guerrero 0 points N/A Posted on - 03/15/2013

Hi,

I installed AuoCAD. But I faced a problem while I tried to launch the AutoCAD 2013 this error message is appearing. The error message says,

WHIP failed to initialize.

                        OK

• Status: Open
• Question Views: 879
• Answer Count: 2
• Vote Up 0 Vote Down

• Answer Accepted: Yes
• Question Category: Photos / Graphics Soft.

Best Answer by Brown Dubin

Go To Solution

Answered By Alice R Jones 0 points N/A #175737

AutoCAD LT 2013 Launching Error

Hi James,

You can try reinstalling AutoCAD with “Leave preferences on my computer” unchecked. If that is not possible due to some reason than I would suggest upgrading your graphics card driver and then restarting your system at least once so that the newly installed drivers take effect.

Regards,

Alice

About Alice R Jones

Questions
8

Answers
99

Best Answers
7

• Vote Up 0 Vote Down

• Posted on - 03/19/2013
• Question Category: Photos / Graphics Soft.

Best Answer

Best Answer

Answered By Brown Dubin 5 points N/A #175738

AutoCAD LT 2013 Launching Error

Hello,

That error probably caused by a non-compatible hardware on your system mostly the graphics card that cannot support AutoCAD 2013.

I advise you to check if your graphics card is compatible and if it is, make sure the drivers are up to date. You can visit this link to find out the minimum requirements for AutoCAD 2013 and then you will have to upgrade your system to the minimum standards.

Thank you.

About Brown Dubin

Questions
1

Answers
20

Best Answers
9

• Vote Up 0 Vote Down

• Posted on - 04/30/2013
• Question Category: Photos / Graphics Soft.