Belkin UPS is showing error

Asked By James Belt 0 points N/A Posted on - 02/27/2013

Hi Friends,

 

A couple of days ago I bought a fresh computer with windows 7 64 bit. With it I got a UPS. Later then, I adjust the hardware and attempted to install the software. Unexpectedly Installation aborted and I got an error message which you can see in the below attached image.

Does anybody get this type of error before? I need assistance regarding the installation.

 

Problem: Repeatedly running there is an instance of setup running.

Please exit.

• Status: Open
• Question Views: 700
• Answer Count: 2
• Vote Up 0 Vote Down

• Answer Accepted: Yes
• Question Category: Hardware

Best Answer by Sandra R Butters

Go To Solution

Answered By Luis I Adams 0 points N/A #143668

Belkin UPS is showing error

Hi James,

Quite a few have experienced exactly the same problem. You may try these five simple steps to get through with it.

First, open My Computer
Go to C: (Local Disk)
Find the folder named Belkin_APM_Setting_Up
Delete that folder
Lastly, install the Belkin Management Software again

I hope that this would help you solve your problem.

Regards,

Luis I Adams

About Luis I Adams

Questions
5

Answers
8

Best Answers
2

• Vote Up 0 Vote Down

• Posted on - 03/13/2013
• Question Category: Hardware

Best Answer

Best Answer

Answered By Sandra R Butters 30 points N/A #143669

Belkin UPS is showing error

Hello James Belt,

The error you have mentioned it sometimes occur if the any program running repeatedly on the computer. So to resolve the issue all you need to do is go to the C drive at first, try to locate the folder named Belkin then remove it. Now install the software again hope this time you won’t get any error message.

Thank you.

 

 

About Sandra R Butters

Questions
12

Answers
102

Best Answers
65

• Vote Up 0 Vote Down

• Posted on - 05/09/2013
• Question Category: Hardware