Carrying Out Onkyo Check SP Wire Error Proficiently.

Asked By Edmund Barton 0 points N/A Posted on - 04/17/2017

Hello, I picked up an Onkyo TX-NR579 and connected my six speakers. I get the “Check SP Wires” error message, and then the display goes off. How can carry out Onkyo check SP wire error to solve it?

• Status: Open
• Question Views: 1240
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: OS
• Question Tags: Error | OS

Answered By Egerton Akeen 0 points N/A #294620

Carrying Out Onkyo Check SP Wire Error Proficiently.

Follow, these easy steps by Onkyo to solve SP wire error and then you can blow the roof of the place:

1. Make certain that the power cord is nicely plugged into the wall power socket.
2. Unplug the cord from the wall power-socket, wait for 30 seconds or little less, then again plug it in.
3. The unit will enter the standby mode automatically if the Auto Standby has been set and afterward it will launch.
4. The activation of the protection circuit takes place.

It helps in solving the problem related to the short-circuiting of the wires or when the bare wires touch each other. There can also be an impedance mismatch.

About Egerton Akeen

Questions
1

Answers
20

Best Answers
7

• Vote Up 0 Vote Down

• Posted on - 04/17/2017
• Question Category: OS