Error code: 22 Dichroics ZeissReflectorTurret

Asked By jessielucyy 30 points N/A Posted on - 11/10/2012

In the operation of reflector turret,  I use Microscope CAN29 (COM-port connection). It sometimes causes the problem if ‘reflector turret control’

Then the Error code: 22 appears. Sometimes, ERROR CODE 3 which says ‘Dichroics ZeissReflectorTurret.

Invalid property value’ appears.

This time if I proceed with hardware config MM, it informs me of that turret is okay and ‘MM should synchronize all work sequence with its motion’

Subsequently when multidimensional acquisition is started, it can’t control the turret which is shown in the following screen shot. 

Error code: 22 Dichroics ZeissReflectorTurret. Invalid property value. (Error code: 3). Device error encountered

I need immediate help. Please help.

• Status: Open
• Question Views: 846
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Software Others

Answered By Thomson martin 5 points N/A #144022

Error code: 22 Dichroics ZeissReflectorTurret

Hi Mr. Jessielucyy,

• Code 22 describes that your hardware is disabled from the directory of Device Manager.
• When your hardware device is disabled in Device Manager then Code 22 error will be generated.
• Mostly, Code 22 error means that your device is forced to disable the device due to deficiency of system resources or may be device is manually disabled in Device Manager.
• You can view Properties of  Device manager basis to detect your problem. 

Thanks very much.

About Thomson martin

Questions
2

Answers
44

Best Answers
6

• Vote Up 0 Vote Down

• Posted on - 11/11/2012
• Question Category: Software Others