Error in Configuring Network Using System Config

Asked By FarahSons 0 points N/A Posted on - 09/27/2011

I am new to Linux therefore I am not familiar with the errors and troubleshooting techniques. I want to configure my network using system – config – network but there seems to be an Exception Error.

"Sequence item not a string or unicode object"

 

How can I resolve this error in GNU Linux and what is the reason for this error?

• Status: Open
• Question Views: 837
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Linux Networking

Answered By Jhnasrin 5 points N/A #82034

Error in Configuring Network Using System Config

Hello Farason,

There is very complicated objection. Linux makes some PCs very comfortable, though you don't have to install it. i think you have some apps mistake in installing moment. Check out first, what you disabled from installing. You must have enough space on your PC. When you install Linux more than 1000 files can be saved on your system.

 

RAM, processor as much as possible try to make space available. Actually Linux gives up a different error, if there is not much space. Hard disk space that you need may not matter. You just need to re install in every upgrading services and available space.

 

Try this above mentioned solution.

About Jhnasrin

Questions
0

Answers
10

Best Answers
3

• Vote Up 0 Vote Down

• Posted on - 09/29/2011
• Question Category: Linux Networking