Error in running Message Queuing in Restore Mode

Asked By kim jenkins 10 points N/A Posted on - 10/20/2011

I am receiving Access Denied error while running Message Queuing or the MQBkup when I am on Restore mode. What could be the possible cause of it? I am logged on as the local administrator and I am not running any application that also uses Message Queuing. 

• Status: Open
• Question Views: 1148
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Message Queue

Answered By Clair griffin 10 points N/A #98654

Error in running Message Queuing in Restore Mode

 

Hello there,

 

So while you are running Message Queuing backup (MQBkup) in Restore Mode, you receive the following error: “Access denied. ” What could possibly be wrong? Try to verify again that you are logged on as a local administrator and that there is no other application that is trying to use Message Queuing or trying to load the MQRT.dll.

 

A common problem is that applications which uses MSMQ have open handles to the MSMQ section of registry. Then the backup tool cannot restore that section. Also, test your Message Queuing installation. You can use MQPing in domain mode. Hope this helps! Good Luck to you!

About Clair griffin

Questions
1

Answers
132

Best Answers
38

• Vote Up 0 Vote Down

• Posted on - 10/25/2011
• Question Category: Message Queue