Error shown while trying to install DPM on exchange 2007

Asked By clive walker 30 points N/A Posted on - 07/16/2012

 

Hello,

I want to establish the DPM agent on Exchange 2007 server. When I try installing DPM on exchange 2007, it always results in an error on the screen:

'Error 80070643'

I changed my firewall settings to set this problem, but the same error appeared again.

Next, I revised the DPM agent version, but the problem was still there.

My configuration settings are:

"Exchange 2007 SP1 – on w2k8 x64 

DPM 2007 – on w2k3 r2 32 bit" 

I am not able to solve this problem.

If anybody has encountered this problem and found a solution, please do let me know.

I'll be highly obliged.

Regards.

• Status: Open
• Question Views: 738
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Development Software

Answered By Cabe Gart 0 points N/A #154505

Error shown while trying to install DPM on exchange 2007

Dear,

If you just installed an agent on the server might be restarting. Wait a few minutes after Windows starts for the agent to become available, Otherwise, troubleshoot the problem as follows.

 

1.Make sure that is remotely accessible from the DPM server.

2. If a firewall is enabled on, make sure that it is not blocking requests from the DPM server.

3. Restart the DPM Protection Agent service on, If service fails to start, re- install the protection agent.

Thank you.

About Cabe Gart

Questions
11

Answers
56

Best Answers
13

• Vote Up 0 Vote Down

• Posted on - 08/08/2012
• Question Category: Development Software