Failure of other devices after adding a new SCSI controller

Asked By Maverick Bozo 10 points N/A Posted on - 03/21/2012

You have added a new SCSI controller to the system.The device fails to load properly and causes the failure of other devices also.What is the easiest way to recover the system?

• Status: Open
• Question Views: 841
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Hardware Components

Answered By Michelle Bang 55 points N/A #117245

Failure of other devices after adding a new SCSI controller

1. The recovery is not possible unless you have the correct procedure to install all the necessary things that are required for the successful run of the software.
2. First make sure that you have all the updated things that are required by the SCSI controller and then run them on the system.
3. Use the back usb ports or the back connectors that are directly connected to motherboard so that there is no third communicating device between these two.
4. After that check if any of the ports is not working properly. You can also update the motherboard drivers to completely sure that it is not the problem of the motherboard and that there is something else that is messing the system.

About Michelle Bang

Questions
2

Answers
515

Best Answers
73

• Vote Up 0 Vote Down

• Posted on - 04/24/2012
• Question Category: Hardware Components