Fedora 16 “Unknown error” message in User & Group GUI

Asked By patty white 10 points N/A Posted on - 05/30/2012

Hello

 “Unknown error” is the message I get when I open the User & Group GUI on Fedora 16.  Also by entering the command” system-config-users” the messages “Unknown Error” stays out. Please help me anyone?

Thanks 

• Status: Open
• Question Views: 1066
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Fedora Linux

Answered By Sharath Reddy 590495 points N/A #150078

Fedora 16 “Unknown error” message in User & Group GUI

Entering a command using the command prompt of a Linux operating system is very different from the commands that are usually used on Windows platforms. If you are using the command prompt when the error hits you then maybe you entered a wrong command on the command prompt. You must first know the sets of commands used on a Linux operating system before using its command prompt.

If the problem doesn’t concern the command prompt of the operating system, there is probably some other problems on the system. Try checking the computer for any possible errors. Use a disk utility application to check the system. For a much thorough diagnostics on the system, use a disk utility application like Norton Utilities, or Norton SystemWorks.

About Sharath Reddy

Questions
1

Answers
14599

Best Answers
2290

• Vote Up 0 Vote Down

• Posted on - 06/07/2012
• Question Category: Fedora Linux