Forgot to install something that causes the CCV 1.4.1a problems

Asked By RENFRED RICHARDSON 0 points N/A Posted on - 11/08/2011

Recently I installed Windows XP Professional on my new Pc so that I could use it with my MT table, but there must be something I forgot to install because right now I am running into problems whenever I try to start the new CCV 1.4.1a. Here is the sequence of the events that have occurred since then. I have downloaded the binary and unpacked it and also downloaded and installed the “VS2008 Redist x86”, went to apple store and downloaded and installed quick time. So far none of this has solved the issue and am looking forward to your intervention. Thank you in advance.

• Status: Open
• Question Views: 1309
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Windows XP

Answered By lee hung 75 points N/A #108219

Forgot to install something that causes the CCV 1.4.1a problems

Hello Renfred,

Getting the components that you might have forgotten during the installation and installing them independently on their own will be a bit difficult, since you cannot figure out which specific component you might have left out.

Therefore, I will suggest that you uninstall the operating that you have on your system and do a clean installation but this time ensure that you follow each step carefully during the installation so that you do not end leaving out some important again that will affect the normal performance of your system.

__

Regards
Lee Hung

 

About lee hung

Questions
3

Answers
1451

Best Answers
463

• Vote Up 0 Vote Down

• Posted on - 11/09/2011
• Question Category: Windows XP