GNS3 dynamips test fail error

Asked By eric123 0 points N/A Posted on - 11/23/2012

I have searched and successfully installed GNS3 but whenever I tried to load it I always face Dynamips Failed attempt error. What should I do? Is this an issue of software file that I have downloaded?

• Status: Open
• Question Views: 852
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: Yes
• Question Category: Misc Networking

Best Answer by Parthy Goan

Go To Solution

Best Answer

Best Answer

Answered By Parthy Goan 0 points N/A #162332

GNS3 dynamips test fail error

Ok just follow the following steps,

·         Launch your newly installed GNS3 program

·         Navigate to Edit > Preferences

·         Here click on the Dynamips tab on the left and now you will see a page full of options for dynamips settings.

·         Just click on Test button and wait for 5 seconds until you get Success message.

·         You are done. GNS3 is now ready to be operated.

About Parthy Goan

Questions
1

Answers
100

Best Answers
27

• Vote Up 0 Vote Down

• Posted on - 11/24/2012
• Question Category: Misc Networking