Help in how to type codes in dreambox

Asked By compquest 0 points N/A Posted on - 12/14/2012

Hi, I would just like to ask how I can use codes in dreambox. I already have the codes I need, I just don't know where I to use them, or input them. Thanks!

• Status: Open
• Question Views: 878
• Answer Count: 2
• Vote Up 0 Vote Down

• Answer Accepted: Yes
• Question Category: Hardware Components

Best Answer by Bankk benediict

Go To Solution

Best Answer

Best Answer

Answered By Bankk benediict 0 points N/A #169204

Help in how to type codes in dreambox

Please follow this instructions.

Unplug power from receiver and replug it.

•  Connect USB A-B cable to PC and DM100 again
• Open Xloader and Click on AUTOCOMM and press OK
• Click on Upload and upload the 221A PRIVATEIKS BIN file
• After a few mins, it will complete uploading the file. When complete, click OK and then click on Disconnect and Unplug DM100 from PC.
• Connect the Receiver to plug outlet and to TV, switch on and press 0+0+0+0+EXIT+EXIT to switch from PAL>NTSC!
• Perform a factory reset – Menu > System Settings > Factory Reset, Press OK!

About Bankk benediict

Questions
4

Answers
99

Best Answers
55

• Vote Up 0 Vote Down

• Posted on - 12/25/2012
• Question Category: Hardware Components

Answered By sanso henry 0 points N/A #169205

Help in how to type codes in dreambox

1. Press the TV Mode

2. Hold the SHIFT button for 3 sec. The TV will blink 2x

3. Enter the code you got. The TV will blink once for every code you will enter.

4. The programming will automatically disappear.

5. Check if the TV respond to the code by pressing the MUTE or Volume button.

6. If it doesn't respond, try the other code in the list.

About sanso henry

Questions
1

Answers
22

Best Answers
2

• Vote Up 0 Vote Down

• Posted on - 01/03/2013
• Question Category: Hardware Components