Installation help on Cooler Master V5GT

Asked By Crewe Bob 30 points N/A Posted on - 06/18/2012

I have a NZXT Phantom cabinet. Can someone design an efficient cooling combination (Suction/Exhaust) of my Cooler Master V6GT because I am pretty much confused with all these fans and vents. Thank you!

• Status: Open
• Question Views: 1070
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Fans / Cooling

Answered By Parsh Auguston 0 points N/A #131772

Installation help on Cooler Master V5GT

1. First take two 120 mm fans and put them downside up so that they suck the air from the bottom and blow directly at the whole components including the RAM side and the hard disk side.
2. Take the top left side and place a fan so that it sucks the air in the system from the outside. These two steps will make the inflow of the air in the chassis.
3. Now place 2 fans at the bottom right/front of the chassis so that they suck the air out. This is how you can get a complete air flow inside the chassis. The two sources flowing the air in and the one source flowing the air out.

About Parsh Auguston

Questions
2

Answers
152

Best Answers
12

• Vote Up 0 Vote Down

• Posted on - 08/05/2012
• Question Category: Fans / Cooling