Installing the version v5 of Advanced System Care showing error

Asked By DavidSBernal 10 points N/A Posted on - 07/04/2013

Hello,

I was installing the version v5 of Advanced System Care, and I had my uncle's disk in here, so I was installing, and it’s installed on my uncle's disk.

Then my uncle ejected his disk, and when I was installing on my PC this error came up:

So I click OK and the installer close itself…

BTW in the error says:

The selected UNC unity doesn't exist or isn't accessible.

Is there any way to fix this issue? Thanks.

Error

A unidade ou partiha UNC seleccionada nᾶo existe ou nᾶo estᾴ

acessivel. Seleccione outra.

OK

• Status: Open
• Question Views: 581
• Answer Count: 2
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Software Others

Answered By Davidson Mudge 0 points N/A #171043

Installing the version v5 of Advanced System Care showing error

Hi David,

                Since you are using a disc the computer set the installation like a network install, where in it gets the installation information from a drive other than the root drive. So when the CD installer was ejected then there was no way to get the information from the last drive it did access before. I suggest if you have enough Hard drive space you may want to copy the installer file from the CD to your C: drive in this way you are directly getting the information from your root drive thus accessing the file will not require any UNC.

About Davidson Mudge

Questions
3

Answers
500

Best Answers
197

• Vote Up 0 Vote Down

• Posted on - 07/05/2013
• Question Category: Software Others

Answered By Sharath Reddy 590495 points N/A #314024

Installing the version v5 of Advanced System Care showing error

That error happened because the installer is missing. If you installed the program using the CD, you need to finish the installation before removing the disc or else this error will happen. To fix the problem, insert the disc again then restart the installation. Don’t remove the disc while installing. When the installation is complete, you can now remove the disc.

That should fix the problem. Another way is to copy the contents of the CD to a blank folder. Once this is done, install the program from the folder instead of using the CD. This way you can install the program with or without the disc.

About Sharath Reddy

Questions
1

Answers
14599

Best Answers
2290

• Vote Up 0 Vote Down

• Posted on - 10/29/2018
• Question Category: Software Others