Jumping of computer mouse on the screen

Asked By anonymous 7060 points N/A Posted on - 09/19/2011

My computer mouse sometime jumping across the screen, tell me what is reason behind it?

• Status: Open
• Question Views: 830
• Answer Count: 2
• Vote Up 0 Vote Down

• Answer Accepted: Yes
• Question Category: Hardware

Best Answer by cainet

Go To Solution

Best Answer

Best Answer

Answered By cainet 0 points N/A #80643

Jumping of computer mouse on the screen

Hi Aqeel

If your are using mouse ball, it might  have some dirt on the two rolling stick inside the mouse as the sensor of the ball.

If your using optical mouse you might need to replace your mouse pad with applicable to the sensor of the mouse.

About cainet

Questions
0

Answers
7

Best Answers
5

• Vote Up 0 Vote Down

• Posted on - 09/20/2011
• Question Category: Hardware

Answered By kimanif 0 points N/A #80644

Jumping of computer mouse on the screen

The bad news is that the jumping cursor problem can be due to a number of problems and settings, and so you will give to figure out which solutions will work for you by trial and error.

Here is what they are:

SOLUTION ONE: UNCHECK HIDE CURSOR WHILE TYPING
Go to control panel > "printers and other hardware"> "mouse" > "pointer options". Uncheck "hide pointer while typing" then click "ok."

SOLUTION TWO: CHANGE TOUCHPAD SENSITIVITY
Adjust the touchpad sensitivity (or set it to inactive while typing) by going to Control Panel >"printers and other hardware"–> "mouse" > "pointer options". Check "show the position of the pointer when I press the Ctrl key. "Then click ok
 
SOLUTION THREE: DOWNLOAD DRIVERS
Download updated drivers for touchpad and mouse.

SOLUTION FOUR: SCAN FOR VIRUSES
Check for spyware, viruses.

SOLUTION FIVE: SWITCH PORTS
Switch from USB port to PS/2 port.

If your mouse is not optical it applies it the one with ball.

Remove the rolling ball by disassemble the mouse and clean it.

Dust can make it function in uncertain behavior.

About kimanif

Questions
0

Answers
50

Best Answers
16

• Vote Up 0 Vote Down

• Posted on - 09/21/2011
• Question Category: Hardware