LabVIEW: The VI is not in a state compatible with this operation

Asked By Sofia Cate 20 points N/A Posted on - 09/13/2012

Hi Experts,

I tried to save a developed file of VI on Block diagram of Lab VIEW FPGA VI. But it threw an error message and finally it was saved.

Error

Not enough memory to complete this operation.

                                         OK

I tried to accumulate the program to start with FPGA board. The same error mentioned above occurred. Three times I had to click ok for stopping the compilation and then occurred code generation error as under:

“Error 100 occurred at an unidentified location”

“LabVIEW: The VI is not in a state compatible with this operation. ”

Do you have any idea regarding these problems?

My PC configuration is Intel Core2Duo 3.16GHz, over 100 GB free hard Disk space and 3.25 GB of RAM.

Please help me.

• Status: Open
• Question Views: 1849
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Software Others

Answered By Julinee James 10 points N/A #135262

LabVIEW: The VI is not in a state compatible with this operation

 

Hi,

It seems that the VI is not compatible with your system. According to the error message, the location where the file has to be saved is not identified. This usually happens when any changes have been made to the default location. When the program is installed on your computer, a default location is created. If you try to change this location then the error occurs. Try to change the settings back to the default settings. If you are not able to do so, follow the steps below:

1. Go to Control Panel on your computer and click uninstall a program.

2. Navigate the programs and uninstall the present program.

3. Now reinstall the lab view that is compatible with your system.

4. Restart your computer and run the program.

This should solve your problem.

About Julinee James

Questions
4

Answers
298

Best Answers
35

• Vote Up 0 Vote Down

• Posted on - 09/20/2012
• Question Category: Software Others