Measurement and Automation explorer error

Asked By Nathan T Justice 0 points N/A Posted on - 09/28/2013

Hello,

I was trying to install MAX which is a measurement and automation explorer. I was able to download it from LabVIEW but the setup cannot be initialized. What should I do?

Also can someone suggest MAX alternatives so that if this fails completely I can switch to the other one?

The Operation could not be completed. Operation failed with error code: 7409

Operation failed.

• Status: Open
• Question Views: 773
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Misc Software

Answered By Dale Peers 0 points N/A #181489

Measurement and Automation explorer error

Hi,

Please check that the target and the host reside on the same subnet. There should be no conflict of the IP address conflicts. Make sure to assign a unique IP address to each controller (in case of multiple controllers).

Also, eject the Compact Flash card from the controller and insert it to the Flash Card Reader. Reformat it using FAT mode.

About Dale Peers

Questions
0

Answers
13

Best Answers
3

• Vote Up 0 Vote Down

• Posted on - 10/25/2013
• Question Category: Misc Software