MEP 2013 – crashes when I edit duct placement in MVPART creation

Asked By Harford Maud 30 points N/A Posted on - 08/25/2012

Hi, my MEP 2013 crashes every time I try to create a MVPART using a  pre-defined block and add duct or pipe connections.

I am giving the screenshot of the error message.

FATAL ERROR: Unhandled Access Violation Reading 0x00c8 Exception at 6cd9adf2h

Please tell me how can I get rid of this error.

Thank you.

• Status: Open
• Question Views: 1149
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Photos / Graphics Soft.

Answered By Carl Jack 10 points N/A #159623

MEP 2013 – crashes when I edit duct placement in MVPART creation

Hello Harford,

You can use a patch that is available on the AutoCAD website which supposedly fixes the problem that you are getting. But if you the patch fails you may try the following:

• Reboot your computer.
• There could be too much in the memory that is causing the error to occur.
• You could also minimize on the drawings that you are opening at a go to prevent a lot of memory from being consumed by the application.
• Check if you tried loading AutoCAD on another machine, for AutoCAD seems to be very strict when it comes to the number of machines that you can load the software on.

Regards,

Carl

 

About Carl Jack

Questions
1

Answers
1657

Best Answers
417

• Vote Up 0 Vote Down

• Posted on - 08/27/2012
• Question Category: Photos / Graphics Soft.