NI Data Acquisition error shown

Asked By Steve D Bautista 20 points N/A Posted on - 09/26/2013

Hello,

I have a simple question here for you experts. If anyone has worked with National Instruments (NI), maybe you can help me on this. Whenever I use NI Data Acquisition (NI DAQ) I run into the error message below. I do not know where to start troubleshooting so any help will be appreciated.

Error – 1074134954 occurred at error occurred at: niScope Acquisition.vi

Possible reason(s)

Driver Status: (Hex 0xBFFA0056)

The necessary memory could not be allocated

Software failure has accoured because system was out of memeory. Due to a known problem, it is recommended that the hardware be reset using niScope_ResetDevice() Function.

Status: Open
Question Views: 727
Answer Count: 1
Vote Up 0 Vote Down

Answer Accepted: No
Question Category: Misc Software

Answered By Parsons Kost 0 points N/A #177528