Program doesn’t start using inventor 2010 on windows 7 64 bits

Asked By Grace W Runyon 30 points N/A Posted on - 09/11/2012

Hi there guys,

I need some help with this. 

I use a computer that runs on windows 7 64 bits. 

I work using inventor 2010. Sometimes, the program doesn’t wasn't to start and shows me this error.

I tried to restart the computer, but I still get the same error message. 

 

Error de licencia

 

Network License Manager no puede encounter una

licencia valida.

 

Vuelva a intentario y, si el problema persiste, pongase en contacto con el administrador

del sistema

 

Error [-4.132.0]

 

                                                                   Cerrar

However, a friend of mine was able to install it to his computer without any problem. So, is there a way to repair this?

Thank you very much for your help.

• Status: Open
• Question Views: 1430
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Windows 64-bit

Answered By Mundo Villaro 0 points N/A #133290

Program doesn’t start using inventor 2010 on windows 7 64 bits

Hello Grace,

Probably your software is designed in windows 7 32bit. Here’s my suggestion.

Uninstall the software,

Reinstall by right clicking the installer file (setup.exe) and choose “Run as administrator”

Once installed, right click on the shortcut and choose open file location.

Right click on the targeted file (the “.exe” file) then choose properties, then choose “compatibility” tab check “Run this program in compatibility for” in a dropdown menu choose at least Windows XP 2 or 3. In the bottom, check “run as administrator” Hope it helps.

HTH

About Mundo Villaro

Questions
1

Answers
38

Best Answers
6

• Vote Up 0 Vote Down

• Posted on - 09/15/2012
• Question Category: Windows 64-bit