Resolving error: AnyConnect is not enabled on the VPN server

Asked By k.travolta 0 points N/A Posted on - 07/13/2016

Hi there. I'm setting up the remote access VPN, but I am unable to connect and log in to the server.

While using the AnyConnect client, after configuration of IP address and port number and entering my credentials, I see the message as follows.

AnyConnect is not enabled on the VPN server How can I eliminate the error? Kindly help.

• Status: Open
• Question Views: 5075
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Virtualization

Answered By g56hnewstart 0 points N/A #85100

Resolving error: AnyConnect is not enabled on the VPN server

The error appears when the user is connecting to a group policy which doesn’t have the protocols defined. Look up the policy that is being connected by the user. Logs would be handy for that purpose.

Now, verify if the configuration of VPN tunnel protocol is done.

After knowing the version, you’re using follow the steps mentioned below.

Hope that helps.

About g56hnewstart

Questions
5

Answers
2

Best Answers
0

• Vote Up 0 Vote Down

• Posted on - 07/13/2016
• Question Category: Virtualization