Use of Last Known Good to recover computer

Asked By Benjamin Morgan 10 points N/A Posted on - 03/21/2012

When should i use Last known Good  whenever i want to recover my computer ?

• Status: Open
• Question Views: 888
• Answer Count: 3
• Vote Up 0 Vote Down

• Answer Accepted: Yes
• Question Category: Windows 2000

Best Answer by Tanok Bloran

Go To Solution

Best Answer

Best Answer

Answered By Tanok Bloran 80 points N/A #117526

Use of Last Known Good to recover computer

Last Know Good Configuration is use not to recover your system but to restore it from the last date where it worked fine or before any issues started. It is different from system recovery which is bringing back your computer to its original settings just like when you first bought it. Usually, we use Last Known Good Configuration if:

1. A download might have affected the system performance
2. The system just stopped working properly without any known reasons
3. We just want to go back to the date where the system worked without any issues instead of recovering it and losing our important files in the end of the process 

About Tanok Bloran

Questions
2

Answers
315

Best Answers
100

• Vote Up 0 Vote Down

• Posted on - 03/22/2012
• Question Category: Windows 2000

Answered By Abel Tonja 5 points N/A #117527

Use of Last Known Good to recover computer

Use this command only when system start troubling like, frequent hang, start getting shutdown sometimes automatically, speed gets too slow . Do not run this command again and again.

About Abel Tonja

Questions
0

Answers
103

Best Answers
0

• Vote Up 0 Vote Down

• Posted on - 10/03/2012
• Question Category: Windows 2000

Answered By Vinson forman 0 points N/A #195292

Use of Last Known Good to recover computer

Hi Dear,

Last Good Known settings are very impressive facility in windows 2000 to Windows 8.

It is used when you are unable to work with computer, Windows did not boot, some kinds of errors are generating by itself.

On these conditions you can use "Last Good Known settings" these settings are stored in computer as a restore point.

If you want to do so. Then press F5 key at the startup of computer after the logo of manufacturer.

Than there will be list of Recovery options appeared.

Safe mode.

Safe mode with command prompt etc.

You have to choose "Last good known settings" here.

Your computer will restores some settings and windows will run properly.

Thanks

About Vinson forman

Questions
1

Answers
225

Best Answers
82

• Vote Up 0 Vote Down

• Posted on - 12/15/2012
• Question Category: Windows 2000