Vision Assistant 8.6 Support Image Acquisition from My Smart Camera

Asked By Travis R Land 0 points N/A Posted on - 08/11/2014

Hi there,

I just installed Vision Assistant 8.6 and I have this error. This is not the first error that appears but I would like to know if the program supports image acquisition from my smart camera. Does anyone knows if it supports image acquisition ? How can I find this ?

Thank you !

No Remote System Found.

No compatible remote system on your local subnet were found.

Select Refresh if you want to search again for remote system on your local subnet.

Select ADD Target to add a remote system that is not on your local subnet.

Select Cancel to continue using the same remote system.

• Status: Open
• Question Views: 727
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Misc Software

Answered By Riley Keith 0 points N/A #180498

Vision Assistant 8.6 Support Image Acquisition from My Smart Camera

Travis,

 

Vision Assistant v 8.6 does support smart cameras. It seems that there is an issue when you want to use them.

 

1. Do this to avoid the error messages and be able to use your camera: Open Vision Assistant.ini in a text editor (notepad). Find the file in the following directory: National InstrumentsVision Assistant 8.6
2. Locate the line [Smart Camera Targets] toward the bottom of the file. If you do not see this line, then add it at the bottom. 
3. Add the following text just below [Smart Camera Targets] 

Passwords=""

IPAddress= x.x.x.x 

 

Replace x.x.x.x with your Smart Camera's IP address.

 

RILEY

 

 

 

About Riley Keith

Questions
0

Answers
101

Best Answers
16

• Vote Up 0 Vote Down

• Posted on - 08/17/2014
• Question Category: Misc Software