Which command to use to configure non-Cisco phones

Asked By avah.hannah 30 points N/A Posted on - 07/07/2014

On our Cisco 3560 Switch, there are Vertical IP phones connected to it and the QoS is not yet configured.I just need to verify if to configure non Cisco phones, will it make any difference if I use the command 'auto qos voip trus' instead of 'auto qos voip cisco-phone'?

• Status: Open
• Question Views: 564
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Misc Networking

Answered By Nortan gabriel 5 points N/A #199903

Which command to use to configure non-Cisco phones

Hello,

 

The command “auto qos voip cisco-phone” causes the switch to automatically enable the “trusted boundary” feature. This feature utilizes the CDP (Cisco Discovery Protocol) to specifically detect the absence or presence of a Cisco-brand IP phone. The command “auto qos voip trus” causes the switch to automatically configure the ingress classification on the interface to trust the CoS/DSCP (class of service/differentiated services code point) value that is received in the packet.

About Nortan gabriel

Questions
0

Answers
157

Best Answers
1

• Vote Up 0 Vote Down

• Posted on - 01/29/2015
• Question Category: Misc Networking